RAMP - HALF WIDTH Bolt On Ramp
RAMP - HALF WIDTH Bolt On Ramp
This aluminum bolt on ramp comes fully equipped with a steel, vortexed bumper with pre drilled holes and all parts necessary to install. You will need to remove the rubber bumper on the back of the trailer. Place the ramp up on the bumper studs and tighten down the nut on the stud at the end first. Then lay the ramp down on the ground and tighten the nuts on the rest of the studs. Install the latch on the tail light bracket and the swivel bracket on the ramp to hold the latch.
This ramp will stand approximately 48" tall on the back of the trailer and will be half the width of the trailer and sit inside the tail light bracket so as not to cover any tail lights. An extended length ramp, 60" tall, is also available. The steel bumpers for these ramps have bolt holes on 10" or 11" centers, we will know which one you will need based on which size ramp you order. If you would like us to verify you have ordered the correct ramp, please put your VIN # in the "Special Notes" section.
*Please note: Some of the pictures in this ad represent the color the ramp will be, not the ramp itself.*
Please allow up to 4 weeks build time.
Shipping is not included in price, this will be calculated at checkout.